Swiss watch water phenomenon (1) fogging inside the watch glass, especially when the temperature difference is large. (2) drops of water condensation inside the watch glass. (3) A large number of drops of water are visible on the watch glass and dial. The nature of the Swiss watch water inflow (1) Purified water or distilled water (2) tap water or rainwater (3) Drink or beer (4) sea water (5) cosmetics or chemical reagents or syrup Distilled water is considered the best, corrosive sea water is relatively large, not to mention the chemical reagents. It is imperative to watch the water into the watch as soon as possible to the watch repair shop to do drying, serious water but also to do wash oil treatment. Can not be placed regardless of, if not in time for maintenance, then the water will make the appearance of the steel parts of the watch movement embroidery, rusty parts of the tiny watches usually need to be replaced, the future cost of repairs will be great, Wrist damage is "catastrophic". In addition to the movement of parts, the long-term exposure to moisture can also make the watch's dial, hands discoloration, foaming and corrosion. Swiss watch water after a simple approach Method 1: Ordinary mechanical watches damp, can be several layers of toilet paper or easy to absorb moisture flashes tightly packed watch, on the 40-watt bulb about 15 cm, baking for about 30 minutes, the table can be dispersed water vapor. Do not watch the table close to the fire by direct baking, so as not to make the table subject to thermal deformation. Method two: the table Mongolian inside, bottom shell outward, anti-wear on the wrist, two hours after the water vapor can be eliminated. If the water is serious, it is best to immediately send the table shop wipe oil, remove the movement of water, in order to avoid rusting parts. Method three: with granular silica gel watch has been put together into a sealed container, a few hours later, remove the watch, water that is all gone. This method is simple and economical, the accuracy and life of the table without any damage. After repeated absorption of silica gel, can be dried at 120 ℃ for several hours, water absorption capacity can be renewable, but also repeated use. Note: When not wearing, try not to let the watch damp, so as not to leather deformation; placed near the magnetic items will also affect the accuracy of the watch. In addition, as long as the watch has blisters (unless it is a diving watch ), it is best to check the way to avoid the delay caused by the internal movement of parts seriously damaged. Hot and humid weather, it is easy to make the watch within the oil condensation, stop when there is time to go, slow or stop the phenomenon, and will result in waterproof ring hardening, reducing waterproofing. Particularly noteworthy is that seawater contains salt and is corrosive to metal components, so outdoor activities should also wash the watch case with fresh water to avoid corrosion. Poly fashion watch network Recommended reading: Quartz watch is good or mechanical watch good ladies watch brand list the world's top ten watch brand watch list